Apr
18
Stage one:
Nat settings: Add a UDP forward on port 5060 to port 5060 and send it to the internal IP address of your router
Draytek NAT table
Stage two:
Set up your sipgate account as follows;
VOIP >> SIP Accounts and into Index 1 (assuming this is the first account)
Profile name: Whatever you want
Register via: Auto
SIP port: 5060
Domain/Realm: sipgate.co.uk
Proxy: 217.10.79.23
Display Name: Whatever you want
Account number/Name: Sipgate account number
Check the box for authentication ID
Authentication ID: Sipgate account number
Password: Your sipgate account number password
Expiry time: 10 minutes
NAT Traversal: None
Ring port: Check the box which corresponds to which port you plugged your BT plug into
Ring pattern: Whatever you want
Draytek SIP account
Stage Three:
VoIP >> Phone Settings
Select “Symmetric RTP”
RTP Port start: 16384
RTP Port end: 16482
RTP TOS: IP Precedence 5
Phone1 settings (under index 1)
SIP URL: your_sipgate_number@sipgate.co.uk:5060
Enable Call waiting and Call Transfer
Codec: G.711A
Packet size 20ms
Select “play dial tone only when account registered” (handy for knowing if you are registered when you pick up the phone to make a call)
Click the “Advanced” button
Tone Settings: UK
Caller ID type: FSK_ETSI(UK)
DTMF Mode: SIP INFO (nortel format)
These settings (first published here) were successfully tested by northernNET engineer on 18 April 2010.
If you require further help do not hesitate to log us a ticket.
